Electronic Theatre Controls Emphasis Lighting Control System Manuel d'utilisateur télécharger pdf (Page 158)

148 Emphasis Console v2.0.0 User Manual

time. The dynamic fade time, displayed in purple, follows the fade time stored

with the cue.

Step 11: Press right-arrow [

t] key to set the Follow time. This can be fixed, dynamic or

manual. Type a time value or press [Clear] to set dynamic fade time or Hold.

Hold takes the place of a “Hold for Go” command (see below).

Step 12: Press the down-arrow [

v] key to move to the next step. Repeat steps 5 through

12 for each step in the subroutine that contains cue information.

Step 13: Press [Record] [Enter] to record the submaster. You can also press [Record]

and a submaster bump button to record the subroutine to another submaster.

To add a subroutine style to a step:

Step 1: Select the step you want to modify and press [S8 -Style]. Use [And] and [Thru]

to select multiple steps.

Step 2: Press:

• [1] [Enter] for Loop to Step and enter the step number to loop to, and the

number of loops you want the subroutine to perform. The Loop to Step style

is typically entered in the last step of a subroutine.

• [2] [Enter] for Bounce and enter the number of bounces you want the

subroutine to perform. The Bounce style is typically entered in the last step

of a subroutine, unless a Subroutine Fade step is also in the subroutine. In

that case, the Bounce step will be the next-to-last step.

• [3] [Enter] for Subroutine Fade and enter the fade time. This step will not

auto execute, rather it is an embedded command for the ‘Fade Subroutine’

softkey. Subroutine fade is typically entered in the last step of a subroutine.

• [4] [Enter] for Hold for Go. A Hold for Go step causes the subroutine to stop

and wait for a press of the submaster bump button. Placing a Follow time of

Hold on a cue step performs the same function.

• [5] [Enter] for Filter settings. Enter the Group number you want to perform

the subroutine. Use Group zero (0) to filter all channels. Over-arching Filter

settings usually are placed in the first step of a subroutine.

Note:

You can place many filters in one subroutine. The later filters will reset the earlier ones.

This way you can have a single subroutine affect different lights in different steps.

• [6] [Enter] for Jump to Step and enter the step number to jump to. This style

can be placed anywhere within the subroutine.

• [7] [Enter] for Macro and enter the macro number to fire. This style can be

placed anywhere within the subroutine.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 317 318

Pas de commentaire

Electronic Theatre Controls Emphasis Lighting Control System Manuel d'utilisateur Page 158